Hotpoint Ventilation Hood LI2JBA User Manual

Instructions for Installation and Use  
Electric Hood  
 
9
10  
11  
15  
9
11  
15  
1
16F  
16F  
6
13A  
12F  
13F  
12F  
12A  
7
7
2
8
8
2
F
3
3
5
B
5
Installation  
4a  
4a  
4b  
Warning! The position of the hook points (5 – Rectangular perforations) or the compulsory fastening points (8 – circular drill holes) may be inverted!  
Therefore check the back of the cooker hood in your possession to verify the position.  
 
C
G
Fastening of shelves (optional): Fasten the four side  
supportsRtotheadjacentcabinetsandplacetheshelfon  
the supports S.  
O
N
Z2  
Z1  
C
G
K
M
J
L
L
S
R
P
E
E
 
Installation - only for model with recirculation version fume outlet slots formed directly on the chimney (with no plastic grills)  
9
10  
15  
9
11  
11  
15  
1
12F  
12F  
6
13A  
13F  
12A  
7
7
2
H
F
8
8
2
3
3
5
H
5
4a  
4a  
4b  
 
10  
Installation – Model with rounded border  
10  
11  
12  
15  
14  
15  
13F  
1
3
13A  
3
6
4-9  
7
4-9  
8
7
2
8
5
5
Model with dome (Filter Version)  
D
12  
10  
13  
13  
10  
11  
11  
 
INSTRUCTION ON MOUNTING AND USE  
GB  
Consult the designs in the front pages referenced in the text by alphabet  
letters. Closely follow the instructions set out in this manual. All  
responsibility, for any eventual inconveniences, damages or fires caused  
by not complying with the instructions in this manual, is declined.  
Operation  
The cooker hood is provided with a key or pushbutton control panel  
situated of the frontal part of the cooker hood, depending on the basis  
of the cooker hood type in possession. For proper operation consult  
the text below and the relative illustration:  
a. ON/OFF lighting  
b. OFF motors/Valve  
c. - d. - e. Minimum suction power/ON Valve (c.), medium (d.),  
maximum (e.).  
Installation  
Thecookerhoodmustbeplacedataminimumdistanceof60cmfrom  
the cooking plane for electric cookers and 70cm for gas or mixed  
cookers. The hood can be installed above these heights but for  
optimum performance it should be installed at the distance quoted for  
the appropriate heat source.  
f. Operation warning light (where present).  
Do not tile, grout or silicone this appliance to the wall. Surface  
mounting only.  
Do not fix chimney flue to furniture or fly over shelves unless the  
chimney flue can be easily removed, in case maintenance is ever  
required.  
a
b
a
b-c-d-e  
b-c-d-e  
Use  
a
d
e
d
e
a b-c  
f
The cooker hood is provided with an upper air exit B for discharging  
fumes externally for models including chimney flue C ( Suction  
Version A- exhaust pipe 13A not supplied).  
c
Intheinstancewhereitisnotpossibletodischargecookingfumesand  
vapours externally even if utilising the model with chimney flue C, the  
cooker hood may be used in the filter version F by mounting two  
active carbon filters E, the fumes and vapours are then recycled via  
the upper grill G (depending on the model the grill may be directly  
placed on the chimney flue or via the mounting of two small grills –  
16F).  
Use the high suction speed in cases of concentrated kitchen vapours.  
It is recommended that the cooker hood suction is switched on for 5  
minutes prior to cooking and to leave in operation during cooking and  
for another 15 minutes approximately after terminating cooking.  
If in possession of a model with grill placed on chimney flue then two  
H extensions must be placed on the deflector 13F.  
Only in the case of models with electric valve:  
In this case the hood is provided with a control panel placed on the  
front part of the hood with two keys, one for turning the lamp on and  
off and one for opening and closing the valve.  
The models provided with small dome D may only be used in thefilter  
version F.  
The models without suction motor and the models with electric valve  
Attention:openingandclosingthevalveisneverimmediateandtakes  
place after a brief lapse of time.  
only function in the suction version and must be connected to a  
peripheral suction unit (not supplied).  
Model with electronic controls  
Electrical connection  
The electrical tension must correspond to the tension noted on the  
label placed inside the cooker hood. Connect the electrical plug,  
where provided, to the an easily accessible outlet in conformity with  
local standards in force.  
Where an electrical plug is not provided (for direct connection to  
electrical network) place a standards approved bipolar switch with an  
aperturedistanceofnotlessthan3mm(accessible)fromthecontacts.  
5 6  
7
2
1
3 4  
8
9
1-Motor OFF button  
2- ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - .  
. . .  
3-Speed  
4-Speed  
1
2
LED  
LED and metal grease filter  
saturatio  
case, the LED will flash - See instructions on grease filter  
cleaning).  
5-Speed  
3
LED and active carbon filter (in tshaisturatio  
latter case, the LED will flash - See instructions on active carbon  
filter replacement).  
Warning!  
The active carbon filter saturation LED is not activated.  
In order to activate the active carbon filter saturation indicator,  
press buttons 2 and 7 simultaneously for 3 seconds. Initially,  
onlyLED4willflash,thenafterthe3secondshavepassed,LED  
5 will also start flashing, indicating that the active carbon filter  
saturation control system is active.  
To switch off the system, re-press the same two buttons: after  
3 seconds LED 5 will stop flashing and the device will be  
 
INSTRUCTION ON MOUNTING AND USE  
GB  
switched off.  
6 -Intensive speed LED  
Carbon Filter  
(2 pieces – only for filter version)  
7 -Intensive speed ON switch  
The active carbon filters E are not washable nor regenerative.  
It should be changed every 6 months in normal use.  
The active carbon filters capture unpleasant cooking odours.  
Apply one on each side covering both grills protecting the motor  
propeller, then turn the filter central handles P clockwise.  
In order to dismantle turn the central handle P anti-clockwise for each  
filter.  
Only for model with electronic control panel:  
Once you have replaced the charcoal filter, press button 1 (see  
precedingpage)forabout3secondsuntilyouheartheacousticsignal  
(beep).  
This speed should be used when the concentration of cooking  
fumes or odours is particularly strong (for example when frying,  
cooking fish etc.).  
Thefastspeedwillrunforabout5minutes  
andthenreturntothespeedpreviouslysetautomatically(1, 2or  
3), or switch off if no speed was selected. Toturnoffthefast  
speed, before the end of the 5 minutes, press button 1 or button  
2 (see page 13).  
8 -OFF lamp button  
9 -ON lamp button  
If the hood fails to operate correctly, briefly disconnect it from the  
mainspowersupplyforalmost5sec.bypullingouttheplug.Thenplug  
itinagainandtryoncemorebeforecontactingtheTechnicalAssistance  
Service.  
LED 5 will now stop flashing.  
Replacing lightbulbs  
Remove the anti-grease filter support grill or the anti-grease filter to  
attain access to the lightbulb area. Remove the damaged lightbulb  
and replace with an incandescent oval bulb max. 40W E14.  
If the cooker-hood comes with a halogen light, take off its protection  
by unscrewing (Z1) or by removing it (Z2 lifting with a small flat edged  
screwdriver). Remove the damaged bulb and substitute it with a max  
20W halogen bulb (G4).  
Maintenance  
Prior to any maintenance operation ensure that the cooker hood is  
disconnected from the electrical outlet.  
Cleaning  
Thecookerhoodshouldbecleanedregularlyinternallyandexternally.  
For cleaning use a cloth moistened with denatured alcohol or neutral  
liquid detergents. Avoid abrasive detergents.  
Warning:  
Caution  
This appliance is designed to be operated by adults. Children should  
not be allowed to tamper with the controls or play with the appliance.  
Do not use the cooker hood where the grill is not correctly fixed! The  
suctioned air must not be conveyed in the same channel used for  
fumes discharged by appliances powered by other than electricity.  
The environment must always be adequately aerated when the  
cooker hood and other appliances powered by other than electricity  
are used at the same time. Flambé cooking with a cooker hood is  
prohibited. The use of a free flame is damaging to the filters and may  
cause fire accidents, therefore free flame cooking must be avoided.  
Frying of foods must be kept under close control in order to avoid  
overheatedoilcatchingfire.Carryoutfumesdischarginginaccordance  
with the regulations in force by local laws for safety and technical  
restrictions.  
Failure to carry out the basic standards of the cleaning of the cooker  
hoodandreplacementofthefiltersmaycausefirerisks. Thereforewe  
recommend oserving these instructions.  
Anti-grease Filter –  
If situated inside the support grill, it may be one of the following types:  
Paper filter must be replaced once a month or if colouring appears  
on upper side, in such cases the colouring is evident through the grill  
openings.  
Sponge filter should be washed with hot soapy water once a month  
and replaced every 5 to 6 washes.  
Metallic filter must be cleaned once a month, with non abrasive  
detergents, by hand or in dishwasher on low temperature and short  
cycle.  
To obtain access to the grease filter J open the grill K via the hooks  
L and free the grill from the stoppers M.  
Some models are provided with a metal filter N without support  
grill,thisfiltershouldbewashedasinstructionsnotedformetallicfilter  
above and is removed from its placing by pushing the handles O  
towards the back and sliding the filter N downwards.  
When washed in a dish-washer, the grease filter may discolour  
slightly, but this does not affect its filtering capacity.  
Only for model with electronic control panel:  
Once the grease filters have been cleaned, press button 1 (see  
precedingpage)forabout3secondsuntilyouheartheacousticsignal  
(beep): the LED 4 will now stop flashing.  
 
 
 
After Sales Service  
"No company is better positioned to offer an after sales service on a  
Hotpoint appliance than us - the manufacturer"  
As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive  
parts and labour guarantee for the first 12 months. In addition to this you also have the advantage of  
free replacement parts for the first 5 years when fitted by a Hotpoint  
engineer. When the 12 months parts and labour guarantee expires we offer the following after sales  
service options:  
Repair Service and Information Help Desk  
UK: 08709 066066  
Republic of Ireland: 1850 302 200  
Note: Our operators will require the Model number and the Serial number of your appliance  
Available 364 days a year with a fast, effective and value for money service. We have the largest  
white goods repair service in the UK with over 1000 of our own fully trained engineers. All repairs  
include a parts and labour guarantee for 12 months from the date of the repair.  
If you require any information or have any questions about your appliance, our operators are on hand  
with help and advice.  
All this ensures that you will receive the best available after sales service possible.  
Extended Warranties  
UK: 08709 088 088  
Republic of Ireland: 1850 502 200  
Whether you have just one or a number of Hotpoint appliances in your kitchen, we offer two service  
cover plans to give you total peace of mind.  
Repair Protection Plan  
-
FREE service repairs for a single Hotpoint appliance during the  
period of cover.  
FREE service repairs for all your Hotpoint appliances less than  
Kitchen Cover  
-
8 years old.  
Genuine Parts and Accessories  
UK: 08709 077 077  
Republic of Ireland: (01) 842 6836  
A wide range of genuine parts and accessories are available from our hotline or through our website.  
Genuine parts and accessories, extended warranties and service repairs are all  
available on our web-site at:  
7
GB91 0  
 
Key Contacts  
After Sales Service  
Over 1200 trained specialists, directly employed by us, ensure that you can have complete  
confidence in both the appliances and services we offer.  
Repair Service and Information Desk  
UK: 08709066 066  
(Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays)  
Republic of Ireland: 1850 302 200  
Note: Our operators will require the following information:  
Model number:  
Serial number:  
Extended Warranties  
UK: 08709088 088  
(Open 8 to 8 Mon - Sun)  
Republic of Ireland: 1850 502 200  
Genuine Parts and Accessories  
UK: 08709077 077  
(Open 8-30 to 5-30 Mon - Fri & 9to 12 Sat)  
Republic of Ireland: (01) 842 6836  
Indesit Company, Morley Way , Peterborough, PE2 9JB  
LI2JBA Ed. 12/04  
 

GPX Portable Multimedia Player MT861B User Manual
Graco Stroller PD202866A User Manual
Haier Air Conditioner hsu 71hek03 r2db 0 User Manual
HannsG Computer Monitor JG191A User Manual
Hans Grohe Plumbing Product 37200 User Manual
Healthrider Treadmill 900hrc User Manual
Honeywell Humidifier HE360A1075 User Manual
Hubbell Work Light K 32 User Manual
Hunter Fan Fan 20431 User Manual
Hunter Fan Thermostat 44110 User Manual